Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Configure panstamp remotly
12-27-2017, 08:55 PM
Post: #1
Configure panstamp remotly
Hi,
I'm working on IoT project in which I use panstamp NRG 2.0 as a wireless device.
I would like to configure (example, change the Tx interval of sending, etc.) the panstamp nodes (having AA batteries, connected to some sensors like humidity and temperature) via the gateway node connected to laptop.
I would like to know firstly if it is possible? If someone work on that?
Thanks in advance Smile
Find all posts by this user
Quote this message in a reply
12-27-2017, 09:22 PM
Post: #2
RE: Configure panstamp remotly
Hi Sakh,

You can remotely change any deice address or txInterval from SWAPdmt:
https://github.com/panStamp/panstamp/wik...e-version)

Regards,

Daniel Berenguer
http://www.panstamp.com
Visit this user's website Find all posts by this user
Quote this message in a reply
12-27-2017, 11:12 PM
Post: #3
RE: Configure panstamp remotly
Hi,
Thanks for the quick answer.
I tried with Swapdmt interace. I upload the code of current meter in the panstamp. I would like that node will transmit its packets to the gateway connected to laptop. I'm now in the step of creation of swap network. Can you provide me please the code related to the gateway device?
Thanks in advance Smile
I attached here a picture for the current state.


Attached File(s) Thumbnail(s)
   
Find all posts by this user
Quote this message in a reply
12-29-2017, 05:03 AM
Post: #4
RE: Configure panstamp remotly
The graphical version of SWAPdmt is outdated. Better go with the command-line version (link posted on my previous post)

Daniel Berenguer
http://www.panstamp.com
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)