Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Programming an NRG-2 using SBW/ MSP-FET430UIF
12-31-2017, 11:08 AM
Post: #1
Programming an NRG-2 using SBW/ MSP-FET430UIF
I have a CCS project which I need to program into my NRG-2.

The NRG-2 Wiki Page states that it can be programmed using SBW.

When I try to program my NRG-2 on a PanStick using a MSP-FET430UIF in SBW mode, I get “Error connecting to the target: Unknown device

Programming via ordinary USB from the Arduino IDE using a simple sketch does work.

Any help will be appreciated!
Find all posts by this user
Quote this message in a reply
01-01-2018, 02:40 AM
Post: #2
RE: Programming an NRG-2 using SBW/ MSP-FET430UIF
Programming via SBW won't work on modules assembled on panSticks. TST and RST pins are connected to the FTDI converter and you need these pins for the SBW communication.

Daniel Berenguer
http://www.panstamp.com
Visit this user's website Find all posts by this user
Quote this message in a reply
01-01-2018, 03:10 PM
Post: #3
RE: Programming an NRG-2 using SBW/ MSP-FET430UIF
Thank you Daniel, that makes sense.

I am now using the Arduino IDE’s downloader (BsLoader.jar) to program my PanStamp from CCS and it seems to be working well.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)